Kanguru 4HD SATA - Manual (Page 41)

41
3.4.7.2 Disabling Security
When the Security function is disabled the KanguruClone will operate as normal without any password
requirements. If the Security function is already enabled, you will need the four digit password in
order to disable it.
INPUT PASSWORD: 0000
<- Cancel UP/DN: Change
Set ->
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
POWEROFF WAIT: 0s
CAP. CHK: DISABLE
Security: ENABLE ->
<- Back UP/DN Sel ->
1. From the Main Menu, press the LEFT button. You will be
prompted to enter the password before you can access the
Setup Menu if the Security function is enabled. Enter in the
four digit password and press the RIGHT button to enter the
Setup Menu.
2. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
3. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the SECURITY function.
Press the RIGHT button to enter the SECURITY Setup
Menu.
4. From the SECURITY Setup Menu, press the UP or Down
buttons to set all four digits to 0.
5. When you finish adjusting the fourth digit, press the RIGHT
button to confirm the Security password. You will be returned
to the CONFIGURATION Function Menu and Security
should be listed as DISABLE. If you want to exit before
disabling the security function, press the LEFT button until
you return to the CONFIGURATION Function Menu.
Security:0000
<- Cancel UP/DN:CHANGE
POWEROFF WAIT: 0s
CAP. CHK: DISABLE
Security: DISABLE ->
<- Back UP/DN Sel ->
Security