Kanguru 4HD SATA - Manual (Page 37)

37
3.4.4 Power On Wait
The Power On Wait function allows you to configure the KanguruClone’s booting time. Some devices
cannot be identified immediately by the KanguruClone; this is because the KanguruClone needs
more time to initiate the attached devices before they can respond to the system. The Power On Wait
function can be increased to allow the KanguruClone more time to detect these devices. The default
value is 12 seconds.
Note: If you are using large capacity hard drives or “green” power saving drives, it is recommended
that the Power On wait time is set to a minimum of 12 seconds.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
TRAN MODE: AUTO
PWN ON MODE: BOOST
POWERON WAIT: 12s ->
<- Back UP/DN Sel ->
POWERON WAIT:12s
<- Back UP:ADD DN:DEC
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the POWERON WAIT
function. Press the RIGHT button to enter the POWERON
WAIT Setup Menu.
3. From the POWERON WAIT Setup Menu, press the UP or
DOWN buttons to increase or decrease the Power On Wait
time. Press the RIGHT button to confirm the Power On Wait
time.
Power On Wait