Kanguru 4HD SATA - Manual (Page 47)

47
3.4.13 Trans BLK
The Transfer Block function allows you to define the block size transferred during the various modes.
The available options are: Auto, 1, 2, 4, 8, 16, 32, 64 and 128. The default value is Auto.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
Wipe Cycles: 07
HPA CHK: ENABLE
Trans BLK: Auto ->
<- Back UP/DN Sel ->
( ) AUTO
( ) 1
( ) 2
->
<- Back UP/DN Sel ->
*
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the TRANS BLK function.
Press the RIGHT button to enter the TRANS BLK Setup
Menu.
3. From the TRANS BLK Setup Menu, press the UP or DOWN
buttons to navigate the different block sizes. Press the RIGHT
button to select a Transfer Block mode.
Trans BLK