Kanguru 4HD SATA - Manual (Page 42)

42
3.4.8 Set Pattern
The Set Pattern function is used to define the pattern you want to write to the destination drives. The
user can change the pattern from x0000 to xFFFF. This pattern will be written when you run a Write
Pattern function. Please refer to section 3.2.3 Write Pattern, p.24 for more details.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
CAP. CHK: DISABLE
Security: DISABLE
Set Pattern ->
<- Back UP/DN Sel ->
Set Pattern: 0x000
<- Cancel UP/DN: CHANGE
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the SET PATTERN function.
Press the RIGHT button to enter the SET PATTERN Setup
Menu.
3. From the SET PATTERN Setup Menu, you will see four 0’s.
Press the UP or DOWN buttons to adjust the left most digit.
Press the RIGHT button once to move to the next digit to
the right and then use the UP or DOWN buttons to adjust it.
Continue until all four digits have been adjusted.
4. When you finish adjusting the fourth digit, press the RIGHT
button to confirm the pattern. If you want to exit the SET
PATTERN Setup Menu before you set the pattern, press the
LEFT button until you return to the CONFIGURATION
Function Menu.
Set Pattern