Kanguru 4HD SATA - Manual (Page 34)

34
3.4 Configuration Functions
The Configuration functions will allow you to change the way the KanguruClone operates. You can
configure system settings as well as configure the way other functions operate. The Configuration
functions are: HD Mode, Trans Mode, PWN On Mode, Power On Wait, Power Off Wait, Cap. CHK,
Security, Set Pattern, Set Copy Areas, Set Copy Ratios, Wipe Cycles, HPA CHK, Trans BLK, Btn.
Snd., HD Info, Load Default, Update Version and About.
3.4.1 HD Mode
The HDD Mode function allows you to configure the translation method.
There are 4 modes:
• Auto – The KanguruClone will automatically choose the CHS (Cylinder Head Sector) translation.
This is the default setting.
• LBA – Translates the physical number of heads to 255. This is the most common translation
method used by most PC BIOS systems.
• Large – Translates the physical number of heads to 128 or 240. Use this translation method if
the Target Drive fails to boot using the LBA translation method.
• Normal – Enables normal CHS Translation.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
HD MODE: AUTO
TRAN MODE: AUTO
PWN ON MODE: BOOST
->
<- Back UP/DN Sel ->
( ) AUTO
( ) LBA
( ) LARGE
->
<- Back UP/DN Sel ->
*
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the HD MODE function.
Press the RIGHT button to enter the HD MODE Setup
Menu.
3. From the HD MODE Setup Menu, press the UP or DOWN
buttons to navigate the different modes. Press the RIGHT
button to select an HD Mode.
Configuration Functions / HD Mode