Kanguru 4HD SATA - Manual (Page 36)

36
3.4.3 Pwn On Mode
The Powering On Mode function allows you to configure the way the KanguruClone powers the ports
after the unit is powered on. The powering on modes are: Boost and Sequential. When set to Boost,
the KanguruClone will power on every port at the same time. Boost mode is quicker than Sequential
mode. The default value is Boost.
When set to Sequential, the KanguruClone will power on the ports sequentially by rows. The
KanguruClone 4HD will power on Port A first, then B, then C and then D. For the Kanguru Clone
12HD, ports A, E and I will power on first, then ports B, F and J, and then ports C, G and K and finally
ports D, H and L. Please refer to the following diagrams for details on the port locations.
Note: Boost mode uses more power than sequential mode. If your power supply is low, use Sequential
mode.
4HD 12HD
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
HD MODE: AUTO
TRAN MODE: AUTO
PWN ON MODE: BOOST ->
<- Back UP/DN Sel ->
( ) BOOST
( ) SEQ.
->
<- Back UP/DN Sel ->
*
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the
UP or DOWN buttons to navigate to the PWN ON MODE
function. Press the RIGHT button to enter the PWN ON
MODE Setup Menu.
3. From the PWN ON MODE Setup Menu, press the UP or
DOWN buttons to navigate the different modes. Press the
RIGHT button to select a Powering On Mode.
Pwn On Mode
MASTER
A B C D
MASTER
I J K L
E F G H
A B C D
▲
▬
▲
▬
▲
▬
▲
▬
1st row 2nd row 3rd row 4th row
▲
▬
▲
▬
▲
▬
▲
▬
1st row 2nd row 3rd row 4th row