Kanguru 4HD SATA - Manual (Page 44)

44
3.4.10 Set Copy Ratios
The Set Copy Ratios function is used to define the beginning and ending of the percentage of the drive
you want to copy.
DIAGNOSTIC
TOOL
CONFIGURATION ->
<- Back UP/DN Sel ->
Set Pattern
Set Copy Areas
Set Copy Ratios ->
<- Back UP/DN Sel ->
Head (1/1000): 000
Tail (1/1000): 000
->
<- Back UP/DN Sel ->
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to CONFIGURATION mode. Press the RIGHT
button to enter CONFIGURATION mode.
2. From the CONFIGURATION Function Menu, press the UP
or DOWN buttons to navigate to the SET COPY RATIOS
function. Press the RIGHT button to enter the SET COPY
RATIOS Setup Menu.
3. From the SET COPY RATIOS Setup Menu, press the UP or
DOWN button to select HEAD. Press the RIGHT button to
Enter the HEAD Setup Menu.
4. Press the UP or DOWN buttons to adjust the left most digit.
Press the RIGHT button once to move to the next digit.
Continue until all digits have been adjusted. Press the RIGHT
button to confirm the Head ratio. You will be returned to the
SET COPY RATIOS Setup Menu.
5. Press the UP or DOWN button to select TAIL. Press the
RIGHT button to Enter the TAIL Setup Menu.
6. Press the UP or DOWN buttons to adjust the left most digit.
Press the RIGHT button once to move to the next digit.
Continue until all digits have been adjusted. Press the RIGHT
button to confirm the Head ratio. You will be returned to the
SET COPY RATIOS Setup Menu.
Head (1/1000): 000
< Cancel UP/DN:Change Set >
Head (1/1000): 000
Tail (1/1000): 000 ->
<- Back UP/DN Sel ->
Tail (1/1000): 000
< Cancel UP/DN:Change Set >
Set Copy Ratio