Kanguru 4HD SATA - Manual (Page 26)

26
3.3 Tool Functions
The KanguruClone includes several tools that will allow you to scan, tune or erase hard drives.
These functions are: Full Erase, Scan Disk, Quick Erase, Min Acoustic, Max Performance, HDD
Wipe, Check Sum and Port Test.
3.3.1 Full Erase
The Full Erase function deletes all information on Target hard drives, sector by sector, wiping the
drives clean.
This function will delete all data and file systems on any attached Target hard drives. Once you
execute Full Erase, any data stored on the hard drive(s) will be permanently deleted. Make sure that
you back up any important data before executing the Full Erase.
Note: The difference between the Full Erase function and the Quick Erase function is that Full Erase
will completely erase the Hard Disk and at the same time verify if there are any bad sectors, while
Quick Erase only deletes the boot sector.
COPY
DIAGNOSTIC
TOOL ->
<- Back UP/DN Sel ->
[ ] FULL ERASE
[ ] SCAN DISK
[ ] QUICK ERASE
->
<- Back UP/DN Sel ->
X
[TOOL]
FULL ERASE
Run by ‘>’
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to TOOL mode. Press the RIGHT button to enter
TOOL mode.
2. From the TOOL Function Menu, press the UP or DOWN
buttons to navigate to the FULL ERASE function. Press the
RIGHT button to select FULL ERASE.
3. Press the LEFT arrow twice to return to the Main Menu.
4. Press the RIGHT button to begin the Full Erase.
5. Once the KanguruClone has finished erasing the drive, it
will display a “V” for verified target drives or an “X” for
failed drives.
Tool Functions / Full Erase