Kanguru 4HD SATA - Manual (Page 16)

16
3.1.4 Area Copy
The Area Copy function allows you to copy a defined area of the Master hard drive. You can define
up to 8 allocation sets on a hard drive. You must define the beginning and ending sectors before
using this function. To define the sectors you have to enter the CONFIGURATION mode, select SET
COPY AREA and then define the beginning and ending sectors. For more information on defining the
beginning and ending sectors, please see section 3.4.9 Set Copy Areas, p.43.
COPY
DIAGNOSTIC
TOOL
->
<- Back UP/DN Sel ->
[ ] BRIEF COPY
[ ] RESIZE COPY
[ ] AREA COPY ->
<- Back UP/DN Sel ->
X
[COPY]
AREA COPY
Run by ‘>’
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to COPY mode. Press the RIGHT button to enter
COPY mode.
2. From the COPY Function Menu, press the UP or DOWN
buttons to navigate to the AREA COPY function. Press the
RIGHT button to select AREA COPY.
3. Press the LEFT arrow twice to return to the Main Menu.
4. Press the RIGHT button to begin the Area Copy.
5. Once the KanguruClone has finished cloning, it will display
a “V” for verified target drives or an “X” for failed drives.
Area Copy