Kanguru 4HD SATA - Manual (Page 28)

28
3.3.3. Quick Erase
The Quick Erase function quickly deletes the information in the MBR (Master Boot Record) and the
Partition Table of the hard drive.
Note: The difference between the Full Erase function and the Quick Erase function is that Full Erase
will completely erase the Hard Disk and at the same time verify if there are any bad sectors, while
Quick Erase only deletes the boot sector.
COPY
DIAGNOSTIC
TOOL ->
<- Back UP/DN Sel ->
[ ] FULL ERASE
[ ] SCAN DISK
[ ] QUICK ERASE ->
<- Back UP/DN Sel ->
X
[TOOL]
QUICK ERASE
Run by ‘>’
1. From the Setup Menu, press the UP or DOWN buttons to
navigate to TOOL mode. Press the RIGHT button to enter
TOOL mode.
2. From the TOOL Function Menu, press the UP or DOWN
buttons to navigate to the QUICK ERASE function. Press
the RIGHT button to select QUICK ERASE.
3. Press the LEFT arrow twice to return to the Main Menu.
4. Press the RIGHT button to begin the Quick Erase.
5. Once the KanguruClone has finished erasing the drive, it
will display a “V” for verified target drives or an “X” for
failed drives.
Quick Erase