Ivoclar Vivadent SR Adoro - Manual (Page 76)

76
Adoro
®
General Information
SR
Cementation
Esthetic cementation options are decisive for the harmonious shade effect of composite veneers. Depending of the indi-
cation, SR Adoro restorations can be seated using either adhesive, self-adhesive or conventional cementation methods.
Please read the corresponding Instructions for Use.
The range of available products may vary from country to country.
* Conditioning is not necessary for conventional cementation.
Material SR Adoro
(framework-
free)
SR Adoro
(metal-supported)
SR Adoro
(ZrO
2
-supported)
Indication
Inlays, onlays,
anterior crowns
Crowns, bridges Crowns, bridges
Cementation
method
adhesive adhesive
self-adhesive /
conventional*
adhesive
self-adhesive /
conventional*
Blasting
Cleaning with
Al
2
O
3
at max.
1 bar (15 psi)
Cleaning with
Al
2
O
3
according
to manufactur-
er's instructions
–
Cleaning of the ZrO
2
with Al
2
O
3
at
max. 1 bar (15 psi)
Conditioning /
silanizing 60 s with
Monobond ® Plus
60 s with
Monobond ® Plus
–
60 s with
Monobond ® Plus
–
Cementation system
Variolink ® Veneer,
Variolink ® II,
Multilink ®
Automix
Multilink ®
Automix
SpeedCEM ® ,
Vivaglass ® CEM
Multilink ®
Automix
SpeedCEM ® ,
Vivaglass ® CEM
Observe the following procedure for zirconium oxide frameworks:
– The surface of zirconium oxide-supported restorations may be cleaned with max. 1 bar (15 psi) pressure before
cementation.
– High-strength zirconium oxide ceramics cannot be etched with hydrofluoric acid gel (IPS ® Ceramic Etching Gel), since
no etching pattern is produced.
– Thoroughly clean the restoration with water and blow dry.
– For adhesive cementation, condition the bonding surface of the restoration using Monobond Plus.
Zinc oxide temporary cements are used for the provisional cementation of framework-supported long-term temporaries
with a maximum wear period of 12 months.