Ivoclar Vivadent SR Adoro - Manual (Page 43)

43
Practical
Pr
ocedur
e
for
Fixed
Metal-Supported
Restorations
2 nd opaquer layer and building up the bridge pontic
Apply the second opaquer layer in such a way that the metal framework, and particularly the retention beads, are entirely
covered with opaquer, i.e. as much as required and as little as possible. After that, precure the opaquer for 20 seconds
per segment using the the Quick and then directly polymerize it in the Lumamat 100 or Targis Power Upgrade (Program
2, 11 minutes). Four Intensive Opaquers are available for the individualization of the opaquer layer. The degree of bright-
ness can be heightened by applying Intensive Opaquer white.
Procedure for the bridge pontic
Apply the second opaquer layer in such a way that the framework is completely covered and precure each segment for
20 seconds. Next, build up the hollowed out space on the bridge pontic to the level of the abutment teeth using Transpa
clear and precure for 40 seconds using the Quick curing light. Then, apply a layer of opaquer directly on the inhibition
layer of Transpa clear and precure for 20 seonds. Polymerize immediately in the Lumamat 1000 or Targis Power Upgrade
using Program 2.
Version A:
Full-coverage veneer (ideal space)
Version B:
Partial veneer (limited space)
Apply the second opaquer layer in such a way that it entirely covers the retention beads, ... Apply the second opaquer layer ...
... individualize using Intensive Opaquer ... ... build up the bridge pontic with Transpa clear,
check against the silicone key, precure
for 40 seconds ...
... and precure each segment for 20 seconds. ... and completely cover with opaquer.