Ivoclar Vivadent SR Adoro - Manual (Page 29)

29
Final Polymerization / Tempering
Preparing for polymerization / tempering
After the layering procedure has been completed,
all layers must be precured. Apply SR Gel on the
entire veneering surface ensuring that all areas are
fully covered and the layer is not too thick. Make
sure that all areas are covered and mount the
restoration with the die on the object holder.
... and mount it on the object holder.
Call up Program 3 and start.
Apply a fully covering but not inappropriately thick
coat of SR Gel to the restoration ...
– Calibrate the furnace on a regular basis by means of the L 100 test set. Observe the corresponding
manufacturer's instructions.
Anterior Crown Apparatus Time Program
Precuring time per
segment
Quick 20 s
–
Final polymerization /
tempering
Lumamat
100 / Targis
Power
Upgrade
25 min 3
Practical
Pr
ocedur
e
for
Framework-Fr
ee
Restorations
(Anterior
Cr
owns)
General notes on polymerization / tempering
After the application of SR Gel, mount the restoration on the object holder and place it in the Lumamat 100 or Targis
Power Upgrade furnace in the correct position. The following points must be observed for polymerization / tempering:
– 2 programs (P1 and P3) are available for polymerizing / tempering SR Adoro restorations with and without model.
– Framework-supported SR Adoro restorations are permanently polymerized / tempered without model dies and without
model using Program P3.
– Framework-free SR Adoro restorations are permanently polymerized / tempered on the model dies without model base.
If up to 3 restorations are permanently polymerized / tempered together, Program P3 has to be used. For the
permanent polymerization / tempering of more than 3 framework-free SR Adoro restorations, Program P1 is used.
– If SR Adoro restorations are to be permanently polymerized on the model using Program P1 (e.g. bridges), all removable
model components (pontic rests, neighbouring teeth) have to be removed from the working model. The remaining
weight of the working model must not exceed 400 g.
Lumamat 100 /
Targis Power Upgrade Framework-supported Framework-free
Program 1
– 4 or more inlays, onlays and/or
crowns on dies
Program 3
Metal
– Crowns and multi-unit bridges
with applied SR Adoro Thermo
Guard
Zirconium oxide
– Crowns and multi-unit bridges
without applied SR Adoro Thermo
Guard
– up to 3 inlays, onlays and/or
crowns on dies