Ivoclar Vivadent SR Adoro - Manual (Page 69)

69
Practical
Pr
ocedur
e
for
Fixed
ZrO
2
-Supported
Restorations
Final Polymerization / Tempering
After the layering procedure has been completed, all layers must be
precured. Apply SR Gel on the entire veneering surface ensuring
that all areas are fully covered and the layer is not too thick. Make
sure that all areas are covered and mount the restoration on the
object holder.
General notes on polymerization / tempering
After the application of SR Gel, mount the restoration on the object
holder and place it in the Lumamat 100 or Targis Power Upgrade fur-
nace in the correct position. The following points must be observed
for polymerization / tempering:
– 2 programs (P1 and P3) are available for polymerizing / tempering
SR Adoro restorations with and without model.
– Framework-supported SR Adoro restorations are permanently polymerized / tempered without model dies and without
model using Program P3.
– Framework-free SR Adoro restorations are permanently polymerized / tempered on the model dies without model base.
If up to 3 restorations are permanently polymerized / tempered together, Program P3 has to be used. For the permanent
polymerization / tempering of more than 3 framework-free SR Adoro restorations, Program P1 is used.
– If SR Adoro restorations are to be permanently polymerized on the model using Program P1 (e.g. bridges), all removable
model components (pontic rests, neighbouring teeth) have to be removed from the working model. The remaining
weight of the working model must not exceed 400 g.
Apply a fully covering but not inappropriately thick coat of SR Gel to the
restoration and mount on the object holder.
Lumamat 100 /
Targis Power Upgrade Framework-supported Framework-free
Program 1
– 4 or more inlays, onlays and/or
crowns on dies
Program 3
Metal
– Crowns and multi-unit bridges
with applied SR Adoro Thermo
Guard
Zirconium oxide
– Crowns and multi-unit bridges
without applied SR Adoro Thermo
Guard
– up to 3 inlays, onlays and/or
crowns on dies
Dentin / Incisal Apparatus Time Program
Precuring time per
segment
Quick 20 s –
Final polymerization /
tempering without
model
Lumamat
100 / Targis
Power
Upgrade
25 min 3
Select Program 3 and start.