Ivoclar Vivadent SR Adoro - Manual (Page 20)

20
Polymerization / Tempering
Preparing for polymerization / tempering
After the layering procedure has been completed, all layers must be precured. to make sure that this is the case precure
each segment for 20 seconds using a Quick curing light. Next, apply sR Gel on the entire veneering surface ensuring that
all areas are fully covered and the layer is not too thick.
If necessary, precure one more time and apply a fully covering but not inappropriately thick coat of SR Gel.
General notes on polymerization / tempering
After the application of sR Gel, mount the restoration on the object holder and place it in the Lumamat 100 or targis
power Upgrade furnace in the correct position. the following points must be observed for polymerization / tempering:
– 2 programs (p1 and p3) are available for polymerizing / tempering sR Adoro restorations with and without model.
– Framework-supported sR Adoro restorations are permanently polymerized / tempered without model dies and without
model using program p3.
– Framework-free sR Adoro restorations are permanently polymerized / tempered on the model dies without model base.
if up to 3 restorations are permanently polymerized /tempered together, program p3 has to be used. For the
permanent polymerization / tempering of more than 3 framework-free sR Adoro restorations, program p1 is used.
– if sR Adoro restorations are to be permanently polymerized on the model using program p1 (e.g. bridges), all removable
model components (pontic rests, neighbouring teeth) have to be removed from the working model. the remaining
weight of the working model must not exceed 400 g.
Lumamat 100 /
Targis Power Upgrade Framework-supported Framework-free
program 1
– 4 or more inlays, onlays and/or
crowns on dies
program 3
Metal
– Crowns and multi-unit bridges
with applied sR Adoro thermo
Guard
Zirconium oxide
– Crowns and multi-unit bridges
without applied sR Adoro thermo
Guard
– up to 3 inlays, onlays and/or
crowns on dies