Ivoclar Vivadent SR Adoro - Manual (Page 50)

50
Palatal layering
Final Polymerization / Tempering
Preparing for final polymerization / tempering
Line the palatal fossa with Occlusal Dentin. Complete the pontic and marginal ridges with Dentin material.
Build up the marginal ridges and the tuberculum with Incisal and Transpa materials and slightly coat with Opal Effect 3 and 4.
If necessary, precure one more time and apply a fully covering but not inappropriately thick coat of SR Gel.
It is imperative to observe the following steps when preparing metal-supported SR Adoro restorations for final
polymerization / tempering:
Step 1 – Applying SR Gel
After the layering procedure has been completed, all layers must be precured. To make sure that this is the case precure
each segment for 20 seconds using a Quick curing light. Apply SR Gel on the entire veneering surface ensuring that all
areas are fully covered and the layer is not too thick to prevent the formation of an inhibited layer.