Ivoclar Vivadent SR Adoro - Manual (Page 22)

22
Finishing / Polishing
Finishing
After completion of the polymerization / tempering procedure, completely remove SR Gel from the restoration using
running water and/or a steamer. Carefully remove the restoration from the die while it is still warm. If the restoration is
removed at a later stage, it is advisable to warm up the stone die by means of water vapour. Finish the restoration with
cross-cut tungsten carbide burs and fine diamonds. It is advisable to use low speed and light pressure. Make sure to
rework the entire restoration to remove the inhibition layer of approximately 30 microns from all surfaces. Carefully taper
the margins of the restoration, lightly grind the margins, and adjust proximal and occlusal contact points. Subsequently,
recreate a lifelike tooth shape and surface structure.
Remove SR Gel and carefully lift the restorations off the die.
Finish the surface with cross-cut burs and remove the inhibition layer.
Lightly grind the margins using fine diamonds and tungsten carbide burs ...
... and re-create a true-to-nature surface structure.