Cervical, dentin and incisal layering – Ivoclar Vivadent SR Adoro User Manual
Page 45

45
Practical
Pr
ocedur
e
for
Fixed
Metal-Supported
Restorations
Cervical, Dentin and Incisal Layering
Sealing the
model
Before building up the Dentin and Incisal materials, all parts
of the model that may come into contact with SR Adoro are
sealed. This step helps to prevent the composite from
sticking to the model. Use SR Model Separator to seal
adjoining parts of the model (e.g. stone die and pontic rests).
Apply SR Model Separator in a thin layer, allow to react for a
short time, and remove excess with oil-free compressed air.
Tip
Characterizing the opaquer
After the inhibited layer has been removed, you may individualize sections of the opaquer surface with SR Adoro
Stains. It is advisable to apply a thin layer of Stains in the marginal and interdental area, particularly if space is limited, to
enhance the in-depth shade effect. Subsequently, precure SR Adoro Stains for 20 seconds using the Quick.
Removing the inhibition layer
Thoroughly remove the resulting inhibition layer using a
disposable sponge (do not use a solvent); make sure that the
opaquer surfaces are free of residue. Make sure that the
Opaquer shows a mat-shiny surface.
Characterization
Apparatus
Time
Program
Precuring time per
segment
Quick
20 s
–