Ivoclar Vivadent SR Adoro - Manual (Page 62)

62
Preparing for completion
After polymerization check the curing depth with a probe.
Then, remove the inhibited layer using the monomer of the
corresponding denture base material and a disposable
sponge. This is necessary to prevent streak formation while
completing the restoration. Make sure that the Opaquer
shows a mat-shiny surface. The monomers of cold-curing
denture base materials, such as ProBase Cold, are best suited
to remove the inhibited layer.
Apply a fully covering 2 nd opaquer layer and precure each segment for 20 seconds.
2 nd Gingiva opaquer layer
Apply the second opaquer layer in such a way that the retentions are entirely covered with opaquer, i.e. as much as
required and as little as possible. After that, precure the opaquer for 20 seconds per segment using the the Quick,
immediately mount the restoration on the object holder (without model), and polymerize it in the Lumamat 100 or Targis
Power Upgrade using Program 2.
Polymerize / temper the restoration without the model using Program 2.
When positioning the model casting on the
object holder, make sure that enough light can
reach them (no shadow casting). After
polymerization, check the curing depth with a
probe. If necessary, repeat the polymerization
cycle.
2 nd opaquer layer
(wash)
Apparatus Time Program
Precuring time per seg-
ment
Quick 20 s –
Final polymerization /
tempering
Lumamat
100 / Targis
Power
Upgrade
11 min 2