Operation – IHSE USA 480c Series Draco tera compact User Manual
Page 157
Operation
2013-08-14
157
Direct Switching of Video
1. Start Command Mode with the 'Hot Key'.
For control, the LEDs Shift and Scroll flashes at the keyboard, if
command mode is activated.
2. Enter the index number of the new CPU from the list of favorites and
confirm with
At the same time the Command Mode is closed and the console is
connected to the new CPU with video only.
Example: Switching to favorite CPU 1 with video only
Switch to previous CPU
1. Start Command Mode with the 'Hot Key'.
For control, the LEDs Shift and Scroll flash at the keyboard, if
Command Mode is activated.
2. Press the key
of your keyboard.
At the same time the Command Mode is closed and the console is
connected to the previous CPU with complete control.
If you switch to a previous CPU that was connected with Video Access
before, you will be connected to this CPU with full KVM access.
You can only switch to not used and allowed CPUs with the 'Hot Keys'.
The options Force Connect and Force Disconnect as well as the
restrictions of the User ACL and CON ACL are taken into account.
'Hot Keys' are only supported, if neither Enable User Login nor the
Enable User ACL is selected and the user is logged in the OSD.
Disconnect current connection
1. Start Command Mode with the 'Hot Key'.
For control, the LEDs Shift and Scroll flash at the keyboard, if
Command Mode is activated.
2. Press the key
The Command Mode is closed and the console is disconnected from
the previous connected CPU.
Pos: 105 /806-IHSE/zz_Layout/Seitenumbruch @ 8\mod_1348581820516_0.doc @ 69462 @ @ 1