beautypg.com

6 static routes – Guralp Systems CMG-DCM User Manual

Page 95

background image

Operator's guide

has no effect.

If you are configuring the DCM over an SSH connection, changing any

of the remaining options will cause you to lose contact with it. You
will have to log in to the DCM again (using the same IP address) to

continue configuring.

net.eth.0.broadcast : The broadcast IP address used by the interface.
This can often be derived from the IP address by replacing numbers at

the end with 255.

net.eth.0.gateway : The IP address of the gateway machine (router) on
your network.

net.eth.0.netmask : The network mask to use for the IP interface. A

DCM with an IP address in the domain 192.168.1.

x would normally

use a netmask of 255.255.255.0.

net.eth.0.netaddress : The network address of the DCM. A DCM with

an IP address in the domain 192.168.1.

x would normally use a network

address of 192.168.1.0.

6.6 Static routes

In addition to the standard IP routeing mechanisms, you can define up
to 4 additional static routes from the DCM to other parts of the

network.

These routes are set on the Configuration – Static Routes page.

December 2006

95