Guralp Systems CMG-DCM - Manual (Page 105)

Operator's guide
7 Configuring digitizers
To configure a digitizer, open the Configuration – Serial Ports page
and find the entry for the serial port attached to the digitizer.
Click the Configure – Digitizer link to the right of this entry.
Alternatively, click the same link in the serial port table shown on the
front (Summary) page.
This page allows you to set up Güralp instruments attached to any of
the DCM's serial ports.
Assuming that the DCM has detected an instrument, its current
configuration is now shown on the right side of the page for reference.
In the centre of the page, the settings are repeated in a form that you
can change. Once you have finished making changes, click
Configure
instrument. The DCM will then attempt to alter the settings on the
digitizer to reflect your choices; this done, you should see the message
New configuration successfully saved to attached
instrument.
If the DCM is connected to a PC running Güralp Systems' Scream!
software, you can also configure the digitizers from within Scream!.
See the User Guide for your digitizer model for more details.
December 2006 105