Guralp Systems CMG-DCM - Manual (Page 115)

Operator's guide
Once the data is stored on the DCM, whether in Flash memory or on
the hard disk, it can be retrieved
•
by a remote computer running Güralp Systems' Scream!, or
other GCF-compatible software;
•
by another DCM or AM, also using GCF;
•
by setting up a CD1.0 or CD1.1 transmitter on the DCM;
•
by direct file transfer (using SSH, HTTP, HTTPS, etc.,)
•
optionally, by requesting the data using SeedLink or AutoDRM.
A PC running Güralp Systems' Scream! software can not only collect
data from the DCM, but also configure the module and any
instruments attached to it.
You may need to enable and configure some of these methods before
you can use them: see Chapter 6, page 80, for more details.
Most installations of the DCM will not require any more complex
setting up than the Web configuration system can offer. However, in
some cases you may need to take advantage of the flexibility offered by
the underlying Linux operating system.
December 2006 115