Guralp Systems CMG-DCM - Manual (Page 23)

Operator's guide
When you are done, click Configure instrument to submit the changes
to the digitizer and reboot it.
See “Digitizer output control”, page 107, for full details of what you
can do.
Configuring digitizers with Scream!
If you prefer, you can use Güralp Systems' Scream! software to
configure and calibrate digitizers and sensors through the DCM
module. You can do this either over the network, or using a serial port.
To connect over the network, start the DCM's Scream! server (see ???
REFERNECE) and connect to the DCM using Scream!'s
Network
Control window. The digitizer should appear under an entry for the
DCM in Scream!'s main window.
To connect over a serial link, set the service for the serial port to
gcf_out (see ???REFERENCE), and connect the serial port to your
computer. The digitizer should appear in Scream!'s main window. The
DCM may not appear in this case, because it does not send its own
GCF blocks.
For full details on how to use Scream!, please refer to its own
documentation or the extensive on-line help.
December 2006 23