Guralp Systems CMG-DCM - Manual (Page 20)

CMG-DCM Data Communications Module
Web configuration interface. An initial root username and password
will have been supplied by Güralp Systems; however, you should
check with the DCM's administrator what username you should use.
On a clean install of the Linux distribution, the password for root is
rootme.
Once you have logged in, you will see a Web page similar to this:
The work area on the right displays a summary table describing the
current setup of the DCM's serial ports, and showing how many blocks
of data have been received on each one.
Under the Configure heading are two links for each serial port. Port
provide quick access to the DCM's configuration settings for the port,
and Digitizer allows you to configure a Güralp Systems digitizer
attached to the port REFERENCE???
Scrolling down in this window, you will see
•
a list of all the files currently stored in the on-board Flash
memory, with a link to download each one;
•
a summary of the current status of the DCM's removeable hard
disk;
•
the status of the tamper-proofing subsystem (used mainly on
integrated DCMs and AMs; standard DCMs do not have the
tamper lines exposed, so you can ignore this section);
20 Issue F