Guralp Systems CMG-DCM - Manual (Page 71)

Operator's guide
datatransfer.cd1.sender : Select on to activate the CD1.0 sender. If you
do not want the DCM to transmit CD1.0 data, select off and ignore the
remaining settings.
datatransfer.cd1.sender.sitename : The CD1.0 site name for the DCM.
datatransfer.cd1.sender.receiver : The IP address or hostname of the
remote CD1.0 device.
datatransfer.cd1.sender.port : The network port number to which the
DCM will send CD1.0 data.
datatransfer.cd1.sender.compression : Select on to enable Canadian
compression in the outgoing data stream.
datatransfer.cd1.sender.channel.x : The DCM needs to know the
CD1.0 channel name for each of the streams you want to transmit.
When data comes in on a stream that the DCM recognizes, it will send
it on with this new name. You can configure up to 12 channels to be
transmitted by one CD1.0 sender.
Channel names are normally chosen to conform to the FSDN SEED
naming convention, but you can use different names if you wish. The
CD1.0 sender does not use the current Seed name mappings.
December 2006 71