Guralp Systems CMG-DCM - Manual (Page 64)

CMG-DCM Data Communications Module
5 Data transfer
You can retrieve data from the DCM using a variety of standard
seismic network protocols and formats, including Güralp Systems' own
Scream! software. The options beneath Data transfer are used to
configure these network services.
For data transfer options which use the serial ports of the DCM ( e.g.
DSS summary mode, etc.) you should use the Configuration – Serial
ports pages to set the
serial.x.service option instead (see Section 6.2,
page 82.)
5.1 Scream! server
Scream! is a Microsoft Windows software package designed to
configure and retrieve data from Güralp digitizers. The options on this
page allow you to control how the DCM responds to requests from
Scream!. Depending on your requirements, the DCM can act either as
an instrument in itself, or pass through requests directly to connected
equipment.
datatransfer.scream.server : Select on to allow Scream! to connect to
the module over a TCP/IP connection and receive data as if it were a
connected instrument. The connection can be established over an
Ethernet, wireless, or PPP link. If you do not want to transfer data
directly to Scream! clients, select off.
datatransfer.scream.server.allowserialaccess : The Scream! software
allows you to configure digitizers connected to it by serial links. Select
64 Issue F