Greenheck AMD-xx-TD Transmitter - Manual (Page 31)

31
6.6 – Power Cycle Sensor Network
Power Cycle
Are you sure?
NO
YES or NO
- Diagnostic ALERT Determination
Power Cycle Sensor Network
- SUPERVISOR MENU EXT
Supervisor Menu
Power Cycle Display Available selections:
1. While in Main Menu, use UP or DN to scroll to:
2. Press ENT. Display will indicate:
3. Use UP or DN to scroll to YES if it is desired to cycle Power.
4. With YES displayed, press ENT and Transmitter will cycle power and scan active sensors and enabled sensors,
similar to when power is first turned on (see Section 5.2).
5. Press ESC to return to previous menu ( see Step 1).
The Vari-green is a solid state device having few mechanical parts requiring special periodic maintenance. The
following maintenance steps are not requirements, but guidelines for establishing a maintenance program for your
specific installation.
Operating experience should be used to set frequency of specific types of maintenance.
7.1 – Cleaniness
7.2 - Mechanical
7.3 – Electrical
- Verify condensation (or other sources of liquids) are not present inside the Vari-green.
- Verify CABLE connections between probes and transmitter are secure.
- Verify mounting hardware is secure.
Periodically inspect all wiring to the Vari-green for good connections and absence of corrosion.
7 - Maintenance