Greenheck AMD-xx-TD Transmitter - Manual (Page 21)

21
5.14 – K-Factor Configuration (con’t)
1. While in Operator Menu, use UP or DN to scroll to:
2. Press ENT to enter K-Factor Configuration menu. Display will indicate:
3. Press ENT and display will indicate current setting of K-Factor (OFF or ON).
4. Use UP or DN to change setting. Once desired setting is displayed, press ENT. New setting will be stored in
memory and display will return to K-Factor Configuration menu as in Step 2.
Note: If user desires not to change the setting and return to K-Factor Configuration menu, press ESC. Unit will
remain programmed as it was originally.
5. Use UP or DN to select remaining parameters to be changed.
6. Follow Step 4 to make any changes to parameters.
7. To return to Main Menu, select Return to MAIN MENU in parameter menu and press ENT.
5.15 – Menu Inactivity Timeout Selection
Allows user to select a time (minutes) after which the unit returns to Normal operation if no activity in the Operator Menu.
1. While in Main Menu, use UP or DN to scroll to:
2. Press ENT and display will indicate current timeout value (1 to 30 minutes or OFF).
3. Use UP or DN to change timeout value. Once desired value is displayed, press ENT. New setting will be stored in
memory and display will return to Main Menu.
Note: If user desires not to change the setting and return to Main Menu, press ESC. Unit will remain programmed
as it was originally.
K-Factor
Configuration
Menu Inactivity
Timeout Selection
K-Factor Off/On
Selection
Menu Inactivity
2 Minutes
OFF to 30 minutes,
1 minute increments - K-Factor Configuration
Menu Inactivity Timeout Select
- Network Selection
Operator Menu
Output Calibration Menu