Greenheck AMD-xx-TD Transmitter User Manual
Page 16
16
5.10 – Output 2 Parameter Selection
Allows the selection of which process variables Output 2 represents.
Process variables available for output are: Flow, Temperature, or None.
If Flow is selected, output will represent 0 to Design Full Range (see Section 5.8).
If Temperature is selected, output will represent 0º to 140ºF (-18ºC to 60ºC).
1. While in Operator Menu, use UP or DN to scroll to:
2. Press ENT and display will indicate current setting of Output #2 (Flow, Temperature or None).
3. Use UP or DN to change setting. Once desired setting is displayed, press ENT. New setting will be stored in
memory and display will return as in Step 1.
Note: If user desires not to change the setting and return to Output 2 Parameter menu, press
ESC. Unit will
remain programmed as it was originally.
Line 3 Parameter
Selection
In “Set Custom Text” mode, the pushbuttons can be used in the following combinations to facilitate programming.
ESC + UP
Moves position cursor to the right, one position at a time.
ESC + DN Moves position cursor to the left, one position at a time.
ESC + ENT Exits “Set Custom Text”. Does not enter any changes to the display since the last time ENT was
pressed.
UP + DN
Jumps up five characters at a time, to the desired character.
DN + UP
Jumps down five characters at a time, to the desired character.
ASCII Character Chart
!
*
3
<
E
N
W
`
i
r
{
″
+
4
=
F
O
X
a
j
s
l
#
'
5
>
G
P
Y
b
k
t
}
$
-
6
?
H
Q
Z
c
l
u
↑
%
.
7
@
I
R
[
d
m
v
↓
&
/
8
A
J
S
¥
e
n
w
'
0
9
B
K
T
]
f
o
x
(
1
:
C
L
U
^
g
p
y
)
2
;
D
M
V
-
h
q
z
Output 2 Parameter
TEMPERATURE
FLOW, NONE
TEMPERATURE
Operator Menu
Default selection shown
Available selections
- Display Configuration
Output 2 Parameter Select
- Low Pass Filter Selection