Greenheck AMD-xx-TD Transmitter - Manual (Page 11)

11
Main Menu Selection Description
Operator Password Selection Allows for the selection of password for the Operator Menu, and the
bypassing of the password
Flow Configuration Allows for the configuration of process variable such as: Duct size
and shape, process type, process maximum/units, and percent
lockdown
Display Configuration Allows the selection of parameter to be displayed on Lines 2 & 3,
and display filter
Output 2 Parameter Selection Allows the selection Output 2 parameter
Low Pass Filter Selection Selects amount of filtering applied to the output and to the display
Output Signal Type Selection Allows the selection of signal type for Output 1 and 2
Transmitter Output Calibration Allows for the zeroing and spanning of transmitter analog Outputs
1 and 2
K-factor Configuration Turns K-factor ON or OFF and allows for the calculation or selection
of exponent and gain values
Menu Inactivity Timeout Selection Allows for the selection a time after which the unit returns to
normal operation if no activity in the Operator Menu
Network Configuration Turns the Network ON or OFF, and allows BACnet configuration
Flow Alarm Configuration
(available only with BACnet Network Option) Turns each alarm ON or OFF, select High and Low Setpoints,
Deadband selection and Alarm Delay
Temperature Alarm Configuration
(available only with BACnet Network Option) Turns each alarm ON or OFF, select High and Low Setpoints,
Deadband selection, and Alarm Delay
Operator Menu Exit Returns display to Normal operation
5. Once the desired selection is displayed, press ENT to enter its sub-menu.
Once the desired Selection is displayed, its sub-menu can be entered by pressing ENT.
At any time while in the Operator Menu, User can return to Normal operation mode by pressing ESC or scrolling to:
and pressing ENT.
OPERATOR MENU
EXIT
To better understand the process of Configuration Programming, arrows with pushbutton designation have been
included on the following flow chart of Display Configuration. This will aid in the navigation of the Configuration
Programming Process.
Display Filter
Selection
Line 2 Parameter
VELOCITY
Operator Menu
Display Configuration
Output 2 Parameter
Selection
Display Filter
0 (None)
ENT
ESC
ENT
UP or DN will scroll
between 0 and 5
Line 2 Parameter
Selection
Return to
MAIN MENU
ENT
UP or DN wil scroll
between VELOCITY,
TEMPERATURE, &
CUSTOM TEXT
UP or DN wil scroll
between VELOCITY,
TEMPERATURE, &
CUSTOM TEXT
ESC
ENT or ESC
ENT or ESC
ENT or ESC
ENT or ESC
Line 3 Parameter
Selection
Line 2 Parameter
TEMPERATURE
ENT
DN
DN
DN
DN
UP
UP
UP
UP
This example of navigation is similar for all Operator Menu selections.