Greenheck AMD-xx-TD Transmitter - Manual (Page 30)

30
4. Use UP or DN to scroll through all sensors that have an alert.
Note: Only sensors with an existing alert will be displayed with its alert code.
5. When done, press ESC and display will return to previous menu (see Step 2).
6. Press UP. Display will indicate:
7. Press ENT. Display will indicate:
or if an ALERT does exist, display will indicate:
Definitions fo individual averages ALERT codes are found at the end of this Section.
8. Use UP or DN to scroll through all average alerts.
9. When done, press ESC and display will return to previous menu (see Step 6).
10. Press UP. Display will indicate:
11. Press ENT. Display will indicate current setting (ON or OFF).
12. Use UP or DN to change setting if desired, press ENT.
13. Press UP. Display will indicate:
14. Press ENT and display will return to Main Menu.
ALERT for Averages
ALERT for Averages
NO ALERT EXISTS
Averages Signal
ALERT CODE: 4
Average Velocity is out
of device range
Turns Off/On ALERT
for Missing Sensors
Return to
MAIN MENU
Sensor Alert Code Definition
1 Sensor has not responded
2 Sensor response address incorrect
3 Sensor response command incorrect
4 Sensor signals are out of range
Sensor Alert Code Definition
4 Average Velocity is our of device range
5 Average Volume is out of design range
6 Avg. Velo. & Volu. are out of range
7 Average Temperature out of device range
8 Avg. Velo. & Temp. are out of range
9 Avg. Volu. & Temp. are out of range
10 Velo, Volu, & Temp are out of range