Gasboy Fuel Point Dispenser - Manual (Page 8)

GASBOY Fuel Point System
1-2 03/28/03
FUELING SEQUENCE
Fueling a vehicle with a Fuel Point Vehicle Module (VM) is accomplished as follows:
1. Insert nozzle into vehicle tank. Vehicle ID, fuel control and odometer/hour data is
automatically transmitted from the VM via nozzle (N-Ring) and tank (T-Ring) antennas to the
Fuel Point Reader (FPR).
2. FPR communicates with the Fuel Management System (FMS) CFN or 1000 FleetKey unit.
3. FMS authorizes and records vehicle data.
4. When the nozzle is removed, it suspends the transaction, Reinsertion resumes transaction.
5. Transaction
terminates when dispenser is turned off, nozzle is inserted into another vehicle, or
suspended transaction is not resumed.
6. Transactions are stored in memory for on-demand retrieval and logger printout.
IMPORTANT HOSE MODIFICATION POINTERS - READ BEFORE
PROCEEDING
Modifying the hose at a work bench is recommended. Use appropriate tools and components. For
reliable and long-lasting installations pay particular attention to the following points as you read the
remainder of the manual:
•
Handle the internal hose wire assemblies carefully. Make sure the wire doesn’t become
nicked or cut. A damaged wire within the hose will allow fuel to enter and wick past O-ring
seals inside the jacket, leaking fuel at the connectors and inside the J-box/pre-amp assembly
in the base of the pump.
•
If the system does not read the VM after installation of the antenna, first check for continuity
between the N-ring and pre-amp located in the J-box amplifier.
•
PVC breakaway and nozzle covers are designed to conceal the breakaway connectors and
wire. The covers must be properly installed.