Gasboy Fuel Point Dispenser User Manual

Page 30

GASBOY Fuel Point System

4-6

03/28/03

STEP D: REASSEMBLE HOSE TO PUMP

Install the J-Box/Amplifier: Unless installed
previously, remove the cover and thread the
portable cord fitting to J-Box. Thread J-Box to
I/S metal conduit installed previously according
to the Fuel Point Reader Manual C35628.
Assemble the wired hose to the pump.

Locate and Install Flex Cable Fitting:
Determine a location to install the flex cable
fitting furnished in the small parts kit. Mark the
location and remove the pump trim panel to a
safe location and machine a 7/8” diameter
hose. Reinstall the trim panel and install the
fitting with conduit nut supplied. For
installations using GASBOY-furnished hoses
with swivel lock mechanisms, proceed to Step
E: Complete N-Ring Wiring.

NOTE:

Excess hose wire length can be
coiled and stored within the
pumping unit.

Install Swivel Limit Mechanisms:- Fuel Point-
wired hoses cannot have continuous swivel motion
in the hose assembly. Swivel Limit Kits are
furnished and are to be installed following the
diagram at the right.

4. Clamp the aluminum stop bracket to the

breakaway using clamp furnished. WARNING: Do
not clamp to the hose coupling. Operation of
the swivel and stop bracket can loosen the
threaded coupling.

Install the stop clamp as shown and tighten fully.

Slide all PVC covers in place and proceed to Step
E: Complete N-Ring Wiring.