Gasboy Fuel Point Dispenser User Manual

Page 23

Standard Hose Retrofit

9182

3-5

STEP D : REASSEMBLE

Hose to Pump

1. Install the J-Box/amplifier: Unless

installed previously, remove the cover
and install the portable cord fitting and
thread it to the J-Box. Thread the
assembly onto the I/S conduit which was
installed previously according to the Fuel
Point Reader Manual, C35628.
Assemble the wired hose to the pump.

2. Locate and install flex cable fitting:

Determine a location to install the flex
cable fitting (furnished with the hose kit).
Mark the location and remove the pump
trim panel to a safe location and machine
a 7/8” hole. Reinstall the trim panel and
install the flex cable fitting with conduit nut
supplied. Fully compress tubing in fitting
recess and secure with tiewrap.

3. Complete hose wire installation:

NOTE: Use UL approved thread sealant on all tapered threads.

a. Remove the existing discharge

elbow and discard. Install Fuel
Point elbow from kit. For ¾” hose
installations install the two reducer
bushings supplied.

b. Assemble supplied hose wire

fitting and tighten fully with
wrench.

c. Use Hose 2 Assembly and feed

hose wire loose end through the
elbow and out the small exit fitting.

Cut hose wire lead to
approximately 24” from end of
hose, saving the trimmed wire for
later use.

e. Assemble O-ring (using O-ring

lubricant), tube fitting, tubing and
nylon bushing supplied. Tighten
fitting completely using wrench.

Fully compress tubing against fitting in recess and add tiewrap to hold in place.

g. Feed tubing and wire through the flex cable fitting, adjust and tighten.
h. Using trimmed wire, splice to hose wire using butt connectors supplied and route to J-

Box/amplifier.

Strip wire and connect to amplifier.