Gasboy Fuel Point Dispenser - Manual (Page 12)

GASBOY Fuel Point System
2-2 03/28/03
BEFORE YOU BEGIN
CAUTION:
Assembly and installation of required components may require drilling and/or
sealing parts. Always assemble hose, nozzles, and any components away from
the fuel site in a safe environment where potentially hazardous fumes are not
present.
Use conduit layout drawings in the Fuel Point Reader Manual, C35628 and check installation for
Fuel Point conduits and J-boxes.
All installations must conform with all building/fire codes, all Federal, State, and Local codes,
National Electrical Code, (NFPA 70), NFPA 30, and Automotive and Marine Service Station Code
(NFPA 30A) codes and regulations. Canadian users must also comply with the Canadian
Electrical Code.
APPROVED NOZZLES FOR USE WITH DISPENSER RETROFIT KITS
Standard interchangeable UL-Listed 3/4 and 1" nozzles may be used with Fuel Point. Nozzle
selection may be affected by vehicle type, vehicle tank configurations, locations and opening
diameter. With the nozzle antenna ring (N-ring) installed, check each vehicle for the following:
•
Install a test N-ring on the nozzle. For each vehicle, check the read distance from the N-ring
to vehicle tank (T-ring). Fuel Point will communicate when the rings are no more than 9"
apart provided there is no metal blocking the signal (because N-ring is inside fill collar
opening).
•
Check that the nozzle spout is fully inserted into the vehicle’s tank opening and the vehicle
can be safely fueled. If necessary, use a nozzle with a longer spout (OPW 7H with #5 BHB-
0125 12" spout or Richards Mark 12). Note that longer nozzle may affect pump nozzle
hook/boot configuration.
Vapor Recovery nozzles approved for use with Fuel Point are listed in the table below.
Nozzle MFR. V/R Balanced V/R Balanced V/R Assisted
Short Spout Long Spout
OPW 211V & 211VXS 11VF & 111VXS 11VA & 11VAA
Emco/Wheaton 4015 A4001 & A4005 A4500 & A4505
Husky 5010 5210 V3
Healy ~ ~ 400 & 600
Catlow ~ ~ VM-1
NOTE: The above nozzles are only to be used if the dispenser “replacement label” indicates
acceptability.
For other special applications, call GASBOY Technical Service at 1-800-444-5529.