Gasboy Fuel Point Dispenser - Manual (Page 22)

GASBOY Fuel Point System
3-4 03/28/03
STEP C: FINAL HOSE AND NOZZLE ASSEMBLY
1. Assemble Breakaway and Nozzle: Determine
fuel flow direction and apply thread sealant to all
tapered threads. Assemble breakaway between
Hose #1 and Hose #2 according to
manufacturer’s directions. Install nozzle to Fuel
Point fitting on Hose #1. Tighten all connections
fully.
2. Complete N-Ring Wiring: Assemble N-ring on
nozzle. Strip 1-1/2” from hose wire outer jacket
and ¼” from 2 wires and crimp hose wire to N-ring
butt connectors Pull nozzle cover over the
nozzle, arrange wire to conceal and tiewrap as
needed. Stretch PVC cover to conceal brass wire
exit and tiewrap to close.
Assembly Note: To strip hose wire, first score
outer jacket using 12AWG stripper setting, then
strip using 10AWG setting.
3. Test N-Ring Wiring: Use ohmmeter and test N-
ring circuit for approximately a 35 ohm reading.
4. Test hose mechanically to insure nozzle shutoff
mechanism is operational and all fittings are fully
tightened.
5. Nozzles vary in design. If the handle locking
mechanism does not operate freely, remove the
lock bracket or replace with a nozzle with
mechanism designed within handle area.