Gasboy Fuel Point Dispenser - Manual (Page 11)

03/28/03 2-1
Section 2
GETTING STARTED
GENERAL INFORMATION
The following procedures assume the dispenser to be modified is UL-Listed and has been
installed according to the applicable codes, including a Listed hose assembly, hose nozzle valve,
and breakaway installed according to the manufacturer’s instructions. Apply a UL-classified pipe
lubricant/sealant to all pipe threads. Communications from the vehicle to the Fuel Point reader are
provided by the hose wire. GASBOY recommends that this wire be concealed from the end user
to discourage tampering.
Fuel Point dispensers may be configured in three styles depending on the individual application.
Give careful consideration to the hose style.
Style 1 (Breakaway at Dispenser) and Style 3 (Breakaway at Nozzle) can be constructed from
standard kits. Be sure to specify the kit that meets your particular hose length requirements. Style
3 (Breakaway at the High Hose Clamp) should be specified when a high hose feature is to be
used. Extended hose kits provide for up to a 20-foot main hose length. Style 1 or 2 should be
used where nozzle weight may be a consideration.