Gasboy Fuel Point Dispenser - Manual (Page 29)

Vapor Recovery Retrofit Kits
03/28/03 4-5
STEP C: FINAL VAPOR RECOVERY HOSE ASSEMBLY
1.
Assemble Breakaway and Nozzle: Determine fuel
flow direction and assemble the fuel breakaway
between hose #1 and hose #2 according to
manufacturer’s directions. Tighten all connections
fully.
2.
Complete N-Ring Wiring: Strip 1-1/2” from outer
jacket and ¼” from 2 wires and crimp hose wire to
N-ring butt connectors. Clamp hose and N-ring
tubing using SAE 24 clamp provided. (see diagram
below). Test assembly to insure clamped tubing
restricts the swivel action at the nozzle coupling.
3.
Test N-Ring Wiring: Mate the breakaway
connectors and test n-ring circuit for approximately a
35 ohm reading.
4.
Test Mechanical Assembly: Insure nozzle shutoff
mechanism operates correctly and all threads are
tightened fully.