Gasboy Fuel Point Dispenser - Manual (Page 20)

GASBOY Fuel Point System
3-2 03/28/03
STEP B: CONSTRUCT HOSE ASSEMBLIES (INTERNAL WIRE)
HOSE #1 ASSEMBLY (Nozzle End)
NOTE: All pipe threads must have UL-approved sealant applied and threads tightened fully.
Nozzle and breakaway are supplied by installer.
1.
Refer to the pump diagram found earlier in this manual and determine the hose style required
(breakaway at nozzle, pump, or mid-hose at high hose clamp).
2. Starting at the breakaway end, carefully snake loose end of appropriate wire assembly
through the hose, taking care not to disturb the slack loop. Apply thread lubricant, thread
hose to large fitting and tighten fully.
3.
Assemble the PVC breakaway cover as shown.
4.
Use a pull wire and feed loose hose wire through swivel supplied with the kit. Apply thread
sealant and thread swivel to hose end.
5.
Continuing at the swivel, locate the large fitting kit and remove small compression fitting and
O-ring and feed loose hose wire through large brass fitting and out the wire exit hose.
Reassemble the O-ring and compression fitting and tighten fully. Gently tug on the wire to
confirm it is fully sealed.
6.
Set hose assembly aside and continue by assembling hose 2.