Gasboy Fuel Point Dispenser - Manual (Page 18)

GASBOY Fuel Point System
2-8 03/28/03
USING THIS MANUAL
The remainder of this manual contains procedures for assembling your antenna and hose. The
steps for hose retrofit are summarized below:
STANDARD HOSE RETROFIT
•
STEP A: DISASSEMBLE HOSE
•
STEP B: CONSTRUCT HOSE ASSEMBLIES (INTERNAL WIRE)
Hose #1 Assembly, Nozzle End
Hose #2 Assembly, Nearest Pump
•
STEP C: FINAL HOSE AND NOZZLE ASSEMBLY
•
STEP D: REASSEMBLE
Hose to Pump
•
STEP E: COMPLETE N-RING WIRING
•
STEP F: APPLY POWER AND CHECK INSTALLATION
VAPOR RECOVERY RETROFIT
•
STEP A: CONSTRUCT VAPOR RECOVERY HOSE ASSEMBLIES
Hose 1 Assembly, Pump End
Hose 2 Assembly, Nozzle End
•
STEP B: NOZZLE ASSEMBLY
•
STEP C: FINAL VAPOR RECOVERY HOSE ASSEMBLY
•
STEP D: REASSEMBLE HOSE TO PUMP
•
STEP E: COMPLETE N-RING WIRING
•
STEP F: APPLY POWER AND CHECK INSTALLATION