Gasboy M06245K0XX - Manual (Page 19)

MDE-4506A Atlas™ Pulser Kits M06245K0XX Installation · May 2006 Page 19
Installing the Pulser Kit in Single Unit and 9140 (Kits M06245K004 through M06245K007 and M06245K009 - M06245K011)
6 Loosely secure in place with two washers and two screws.
7 Ensure that the parts are meshed properly and tighten the screws.
8 Ensuring that the wires extend through the conduit, make the necessary connections as shown
in
Figure 9 on page 17 or Figure 10 .
9 Ensure that the wires extend into the junction box.
Connecting the Wires in the Junction Box
1 Remove the screws securing the cover on the junction box. Save screws for remounting.
2 Inside the junction box, connect the green ground lead from the pulser to a secure known
ground.
3 Refer to your Fuel Management System installation manual for proper wiring of the pulsers.
4 Remount the junction box cover and secure it with the screws removed in step 1 .
Testing/Checking Operation
Only the 10:1 pulser can be tested for operation. Using test equipment, others must be tested
when hooked to the pump/dispenser controller. Test the 10:1 pulser as follows:
1 Inform the manager/owner that power will be restored to the unit and then restore power to the
unit.
2 Connect a mechanical voltmeter on the two orange signal wires.
3 Set the voltmeter to read Ohms.
4 Slowly dispense fuel and observe that the needle deflects upscale for each 1/10 gallon fuel.
Completing the Installation
1 After determining that the pulser is functioning properly, remount the dial faces on the
computer and secure them with the screws saved during removal.
2 Remount the bezels on both sides of the unit and secure them with the screws saved during
removal.
3 Remount the doors on both sides of the unit and secure them with the keylocks.
4 Inform the manager/owner that the unit can be returned to service.