Preparation – Gasboy M06245K0XX User Manual
Page 15
MDE-4506A Atlas™ Pulser Kits M06245K0XX Installation · May 2006
Page 15
Installing the Pulser Kit in Single Unit and 9140 (Kits M06245K004 through M06245K007 and M06245K009 - M06245K011)
Installing the Pulser Kit in Single Unit and 9140
(Kits M06245K004 through M06245K007 and M06245K009 -
M06245K011)
Preparation
1
Request permission from the manager/owner to remove power from the unit and then remove
power using normal procedures. Observe the lockout/tagout safety procedures.
2
Using the proper key for the unit, unlock and remove the doors from both sides of the unit.
Place the doors in a safe place to prevent damage or scratches.
3
On both sides of the unit, remove the two screws securing the bezel and remove the bezel.
Store bezels and screws in a safe place for reuse.
4
Remove the screws securing the dial face in place and remove the dial faces from both sides of
the computer. Store the dial faces and screws in a safe place to prevent damage or scratches.
5
Ensure that you have the proper kit for the model dispenser to be retrofitted.
Installing the Drive Gear on the Meter Computer Shaft
In the kit, locate a 043225 pin, a 031035 hub, a 027401 gear, and a K76238-41 retaining ring.
See
.
1
On the computer, press a pin into the hole in the computer shaft until it is flush on one side of
the shaft. For kits M06245K004 through M06245K006 and M06245K009 - M06245K011,
press the pin into the hole in the computer quantity shaft. For M06245K007, press the pin into
the hole in the computer money shaft.
Figure 7: Installing Drive Gear on Meter Computer Shaft
Retaining Ring
Hub
Pin
Computer
Shaft
2
Place a hub on the shaft with the slotted portion of the hub straddling the extending pin and
align the hole in the hub with the pin.
3
Push the pin through the hole in the hub until the pin is extending equally on both sides of the
hub.
4
Place a gear on the hub and align the pin in the shaft with the bearing slot in the gear.
5
Secure the gear in place by placing a retaining ring in the slot near the end of the shaft.