Gasboy M06245K0XX User Manual
Page 18
Installing the Pulser Kit in Single Unit and 9140 (Kits M06245K004 through M06245K007 and M06245K009 - M06245K011)
Page 18
MDE-4506A Atlas™ Pulser Kits M06245K0XX Installation · May 2006
For Kit M06245K007, refer to
Figure 10: Single Money Mechanical Pulser Conduit
Bushing, Reducing
3/4-1/2 (K49827)
Conduit Nipple 1/2x 4
(R11976-57)
Conduit Tee 1/2 inch
NPT (064830)
Union, conduit 1/2
inch (Q10016-04)
Formed conduit
Mechanical Money
pulser grade1
(M05368B001)
Conduit elbow 1/2
90 deg (K42428)
Conduit Nipple
1/2x 1 5/8
(R11976-43)
Elbow, Conduit 1/2x
90 deg (025045)
Pipe plug c-sunk 1/2
(K43850)
Union, conduit 1/2
inch (Q10016-04)
Spacer 0.944
(056877, 056895)
Spacer (056895)
3
Install the M05292B001 or M05368B001 conduit on the pulser and coupling assembly (to the
elbow installed in
4
Remove and discard the two assembly screws and replace them with the two spacers in
positions shown in
. Notice the difference in part numbers
and the position of the spacers.
5
Place the pulser in position by positioning the conduit mounted on the pulser through the slot
in the unit. Ensure that the pinned shaft on the pulser aligns with the center hole in the idler
gear and the pin seats in the slot in the gear. The mounting holes in the mounting plate must
align with the holes in the spacers. Refer to
.