DNF Controls CP20 User Manual
Page 39

Flex Control Network
®
, CP20 User Manual
Page 35 of 42
NEXT CUE
[NEXT]
Step to the next Cue Point Location.
PLAY
[PLAY]
If an OUT point is set, play to the OUT point and
stop. If not OUT point is set, play normally.
Play past OUT point
[SHIFT] + [PLAY]
Press to force the channel to continue to play
past the OUT point (to end of clip).
PREROLL
[PREROLL]
Cues the clip to IN point - PREROLL time. Preroll
time is set in menu.
RECORD
[REC]
Places VTR into the Record mode selected by
RECORD MODE in the SETUP MENU. Press
[RECORD] or [SHIFT] + [RECORD].
RECUE
[GOTO]
If the IN point is set, cue to the IN point. If the
IN point is not set then cue to beginning of clip.
REWIND
[RWD]
Press and HOLD to shuttle. Release key to stop.
Set WIND Speed in MENU.
SET IN POINT
[IN]
Press the [IN] key to set the in point to the
current position.
SET OUT POINT
[OUT]
Press the [OUT] key to set the out point to the
current position.
SET PBIO
PARAMETERS
[SHIFT] + [PBIO]
Press to set the Pbus address and IP address.
See manual.
SHUTTLE
[SHUT]
Select SHUTTLE mode and enable Wheel.
SLO-MO SPEED
PRESET
[SHIFT] + [SLOMO]
For WHEEL ONLY: Press [SHIFT] + [SLOMO]
to preset the slo-mo speed. Turn the Wheel to
select desired speed. Press [ESC] or any
transport key to exit.
SLOW MOTION
[SLOMO]
Press the [SLOMO] key to start play at speed
set by wheel or by [SHIFT] + [SLOMO]. If
slomo set to zero then still frame. Press any
transport key to exit SLOMO.
STOP
[STOP]
Press once to STILL frame VTR. Press again to
put VTR into STOP mode.
TSO -
[PLAY] + [RWD]
Press and hold [PLAY] and press [RWD] to
play at less than play speed (speed set in menu,
max 25%).
TSO +
[PLAY] + [FFWD]
Press the and hold [PLAY] and press [FFWD]
to play at higher than play speed (speed set in
menu, max 25%).
View Cue Data
[SHIFT] + [NEXT]
[SHIFT] + [LAST]
Press to view IN point, OUT point, and GANG
data.
Press to view LEARN or MARK data