DNF Controls CP20 - Manual (Page 33)

Flex Control Network ® , CP20 User Manual Page 29 of 42
F.
G.
Mark a Cue point
With menu setting: MARK CUE=MARK.
1) Press VTR [1], [2], [3], [4], [5], [6], [7] or [8].
2) Load a clip on the selected channel. See section LOAD A CLIP.
3) OPTIONAL:
a. Use the transport functions to view the clip.
b. Press [IN] to set an IN point. The IN LED will turn on. On recall, the
clip will cue to the IN time, not the beginning of the clip.
c. Press [OUT] to set an OUT point. The OUT LED will turn on. On recall,
the clip will play to the OUT point then stop.
d. To delete an IN or OUT point, press and hold [DEL], then press [IN] or
[OUT]. The IN/OUT LED will turn off.
e. If no IN point is set, the current location of the clip will be MARKED as
the IN point.
4) Select the desired Cue Point by pressing [NEXT], [LAST] or by manually
entering the Cue Point using the numeric keypad, followed by [ENTER].
The selected Cue Point number is shown on the bottom part of the display.
5) Press [MARK] to create the Cue point.
NOTE: Play mode is defaulted to "NORMAL" (no loop) for all MARKed cue
points. MARK will overwrite the previous contents of the Cue Point.
6) Press [ESC] at anytime to escape without MARKing.
Learn a Cue point
With menu setting: MARK CUE=LEARN.
1) Press VTR [1], [2], [3], [4], [5], [6], [7] or [8].
2) Load a clip on the selected channel. See section LOAD A CLIP
3) OPTIONAL:
a. Use the transport functions to view the clip.
b. Press [IN] to set an IN point. The IN LED will turn on. On recall, the
clip will cue to the IN time, not the beginning of the clip.
c. Optional- Press [OUT] to set an OUT point. The OUT LED will turn on.
On recall, the clip will play to the OUT point then stop.
To delete an IN or OUT point, press and hold [DEL], then press [IN] or
[OUT]. The IN/OUT LED will turn off.
If no IN point is set, the current location of the clip will be learned as
the IN point.
d. For GANG, repeat steps a. through c. for each channel. Then, press
the [SHIFT] + any [VTR] key enter the GANG mode.
e. Press VTR [1], [2], [3], [4], [5], [6], [7] or [8] to add the VTR to the
GANG. The VTR LED will turn on.
f. Press the VTR key again to remove it from the gang. The VTR LED will
turn off.
g. Press [ENTER] to complete the GANG mode. The LED of all GANGed
VTRs will turn on. The primary VTR's LED will flash.
4) Select the desired Cue Point by pressing [NEXT], [LAST] or by manually
entering the Cue Point using the numeric keypad, followed by [ENTER].
5) The selected Cue Point number is shown on the bottom part of the display.
6) Press [MARK] to initiate the Learn.