Load a cue point, Recue, Search to – DNF Controls CP20 User Manual
Page 35
Flex Control Network
®
, CP20 User Manual
Page 31 of 42
K.
L.
M.
Load a Cue Point
LOAD KEY = LOAD
1) Press [NEXT] or [LAST] key or enter cue number and press [ENTER] on the
keypad
2) Press the [LOAD] key. The clip will be cued to the set in point.
OR
3) If the Cue was saved as a "LEARN" then:
4) Press [SHIFT] + [LOAD] key. All the VTRs that were learned will be loaded
and cued to their in points as well as the learned GANG states.
LOAD KEY = RECALL
1) Press [NEXT] or [LAST] key or enter cue number and press [ENTER] on the
keypad
2) Press the [LOAD] key. All the VTRs that were learned will be loaded and
cued to their in points as well as the learned GANG states.
3) OR
4) If the Cue was saved as a "MARK" then:
5) Press [SHIFT] + [LOAD] key. The clip will be cued to the set in point.
LOAD KEY = REDIRECT
1) Press [NEXT] or [LAST] key or enter cue number and press [ENTER] on
the keypad
2) Press the [LOAD] key.
3) The screen will display softkeys to select the alternate pairs of VTR channels:
{
1,2
}
; {3,4}; {5,6}; {7,8} to which to load the CUE POINT. The clips will
be loaded from channels 1 & 2 to the selected pair of channels with the clip
cued to the beginning of clip or to set in point.
OR
4) If the Cue was saved as a "LEARN" then:
5) Press [SHIFT] + [LOAD] key. (All the VTRs that were learned will be loaded
and cued to their in points as well as the learned GANG states).
6) The screen will display softkeys to select the alternate pairs of VTR channels:
{
1,2
}
; {3,4}; {5,6}; {7,8} to which to load the CUE POINT. The VTRs will
be loaded from channels 1 & 2 to the selected pair of channels with the clip
and cued to the beginning of clip or to set in point.
7) All the VTRs that were learned will be loaded and cued to their in points as
well as the learned GANG states.
Recue
Press [GOTO]. If an IN Point is set (the IN indicator is on), the clip will RECUE
to the IN Point.
If the IN point is not set, the clip will RECUE to the start of the clip.
Search to
1) Press [SHIFT] + [GOTO] then enter the search point on the keypad to cue to
the entered time.
2) Press [SHIFT] + [IN] then [GOTO] will cue to the in point.
3) Press [SHIFT] + [OUT] then [GOTO] will cue to the out point.