DNF Controls CP20 - Manual (Page 38)

Flex Control Network ® , CP20 User Manual Page 34 of 42
9. Function Table
Function Key Press Description
CLIP LIST [CLIP LIST] Press the [CLIP LIST] key to access the clip list
on the server.
FFWD [FFWD] Press and HOLD to shuttle. Release key to stop.
Set WIND Speed in MENU.
GANG RE-SYNC [SHIFT] + [STOP] Press and hold the [SHIFT] key and press the
[STOP] key. This will reestablish the time offset
to the ganged channels. After multiple
play/stop, jog or shuttle operations the offset
between the ganged channels can be off by
several frames.
GANG SETUP
(PERMANENT) [SHIFT] + [any VTR key] Individually press the VTR keys to be included in
the gang. The LED above the key will turn on.
Press the VTR key again to remove from gang.
The LED above the key will turn off. Press
[ESC] to exit. Upon exiting, all members of the
gang will have their VTR LEDs turned on. The
flashing LED shows which VTR is currently
selected.
GANG SETUP
(TEMPORARY) VTR KEYS
(SIMULTANEOUSLY) Press all the VTR keys that are to be part of the
GANG at the same time. The LEDs of the
ganged channels will be on. The first key held
down will be the selected VTR, its LED will flash.
Press any one of the GANGED VTR keys to
cancel the GANG
GOTO ENTERED
TIME
[SHIFT] + [GOTO] Search the VTR to the manually entered time.
Use the CP20 numeric keypad. Press [ENTER]
or [GOTO].
GOTO IN POINT [GOTO] If IN point is set, cue to the IN point.
GOTO OUT POINT [SHIFT] + [OUT] then
[GOTO] If OUT point is set, cue to the OUT point.
JOG [JOG] Select JOG mode and enable Wheel.
LAST CUE [LAST] Step to the previous Cue Point Location.
LOAD AND CUE TO
PREROLL
[SHIFT] + [PREROLL] Press to load cue and cue to preroll point.
Lock VTR to Panel [SHIFT] + [MENU] Press to lock selected VTR to this control panel.
Other control panel cannot access this VTR.
LOOP [LOOP ENABLE] Plays the currently loaded clip in a continuous
loop. If in and out points are set then loop
within those points.
PLAY TO LOOP [SHIFT] + [LOOP ENABLE] IN point must be set. Press [SHIFT] + [LOOP
ENABLE] to cue to beginning of clip. Then
[PLAY] to start PLAY TO LOOP function. Clip
will play from beginning to end and then
continue to loop from in point to out point.
MENU [MENU] Press the [MENU] key to access the menu
items.