DNF Controls CP20 - Manual (Page 28)

Flex Control Network ® , CP20 User Manual Page 24 of 42
E.
F.
G.
7) Press {LRN} or [MARK] to complete the Learn process.
NOTE: Learn will overwrite the previous contents of the Cue Point.
8) Press [ESC] at anytime to escape without LEARNing.
Gang-Temporary (set in menu)
1) Press all the VTR keys that are to be part of the Gang at the same time. The
LEDs will light to indicate that they are part of the GANG. The flashing LED
indicates the selected VTR.
2) Press any VTR key to cancel the GANG.
Gang-Permanent (set in menu)
1) Press the [SHIFT] key + any [VTR] key to start the gang dialogue.
2) Press VTR [1], [2], [3], [4], [5], [6], [7] or [8] to add the VTR to the
GANG. The VTR LED will turn on.
Press the VTR key again to remove it from the gang. The VTR LED will turn
off.
3) Press [SHIFT] to complete the GANG mode. The LEDs of all GANGed VTRs
will turn on and the selected VTR LED will flash.
4) To CANCEL the gang function:
Press the [SHIFT] key + any [VTR] key to start the gang dialogue.
Press the {CLEAR} key to cancel the gang function.
Set IN and OUT points
1) Set an IN Point and/or OUT Point.
Jog/Shuttle to the desired IN Point. Press [IN].
Jog/Shuttle to the desired OUT Point. Press [OUT].
2) Press [IN] to set an IN point. The IN LED will turn on. Optional- Press
[OUT] to set an OUT point. The OUT LED will turn on.
Press [SHIFT] + [IN]. Manually enter the IN time on the numeric keypad.
Press [ENTER].
Press [SHIFT] + [OUT]. Manually enter the OUT time on the numeric
keypad. Press [ENTER].
3) To delete an IN or OUT point, press and hold [DEL], then press [IN] or
[OUT]. The IN/OUT LED will turn off.