DNF Controls CP20 - Manual (Page 9)

Flex Control Network ® , CP20 User Manual Page 5 of 42
2.
A.
B.
C.
IP Configuration
IP Configuration is required after initial installation.
IP Address Setup
1) On the CP20 front panel, press [Menu] to enter the setup menu.
2) Using the shuttle wheel, scroll to the left until the “Current IP Address”
screen is displayed. Display will show current IP address.
3) Press {New IP} to edit the current IP address.
4) Using the numeric keypad, enter the desired IP address for the CP20.
5) Press {SAVE} to save new IP address. Confirmation will be requested
before saving changes. Press {YES} to save the changes, or {NO} to
discard them.
OR
Press {CANCEL} to exit without saving.
NOTE- New IP Address will take effect on next power up.
Subnet Mask Setup
1) On the CP20 front panel, press [Menu] to enter the setup menu.
2) Using the shuttle wheel, scroll to the left until the “Current Subnet Mask”
screen is displayed. Display will show current subnet mask.
3) Press {New Subnet Mask} to edit the current IP address.
4) Using the numeric keypad, enter the desired subnet mask for the CP20.
5) Press {SAVE} to save new subnet mask. Confirmation will be requested
before saving changes. Press {YES} to save the changes, or {NO} to
discard them.
OR
Press {CANCEL} to exit without saving.
NOTE- New Subnet Mask will take effect on next power up.
Gateway Address Setup
1) On the CP20 front panel, press [Menu] to enter the setup menu.
2) Using the shuttle wheel, scroll to the left until the “Current Gateway”
screen is displayed. Display will show current gateway.
3) Press {New Gateway} to edit the current IP address.
4) Using the numeric keypad, enter the desired gateway for the CP20.
5) Press {SAVE} to save new gateway. Confirmation will be requested
before saving changes. Press {YES} to save the changes, or {NO} to
discard them.
OR
Press {CANCEL} to exit without saving.
NOTE- New Gateway Address will take effect on next power up.